H Beam Vs I Beam Connecting Rods

All rods use arp 2000 bolts it is designed for durability with a little more material around the bolt.
H beam vs i beam connecting rods. H beam connecting rods incorporate two large flat sides with a thin section in the middle. They are all 100 machined on all surfaces stress relieved and shotpeened. Depending on the material you would want at least 900 inch of thickness in that area. The ohio crankshaft h beam connecting rod is by far our most popular rod.
H beam rods are more difficult to machine so they are often more expensive. Consequently h beam connecting rods are often recommended for high torque motors that produce a lot of power at low rpm under 6 000 rpm. Basically the h beam itself where the slot is cut out. Ohio crank h beam rods.
H beam is a stronger design when bending stress is considered davis said. With an h beam rod you should look at the thickness of the blades. H beam connecting rods have some additional things you want to look at before you pull the trigger on a set according to norris.